Search:

Search: Search took 1.00 seconds.

  1. Replies
    2
    Views
    7,292

    my 825 did the same thing after doing some...

    my 825 did the same thing after doing some electrical work on it it turned out to be a connection on one of the fuses in fact it did it twice I replaced most of the fuses related to ignition mhope...
  2. Replies
    2
    Views
    3,193

    I believe most of those wires are 14 gauge

    I believe most of those wires are 14 gauge
  3. Replies
    1
    Views
    38,873

    interfearence engine info

    finally was able to get ahold of a john deere tech with question about engine interference the 825 3 cyl and he assured be it was not an interference engine so no worry about destroying the engine...
  4. Replies
    3
    Views
    29,732

    I have a super winch 3000 have used it often for...

    I have a super winch 3000 have used it often for the last 2 years has been a great winch
  5. Replies
    2
    Views
    38,042

    I had the same issue all of a sudden lost all...

    I had the same issue all of a sudden lost all power when turn key on , ended up being a bad ign switch
    to check pull switch out and test terminals with a test light should have one hot all the time...
  6. Thread: trouble codes

    by campoman
    Replies
    4
    Views
    38,839

    thanks for the info Brad going to purchase the...

    thanks for the info Brad going to purchase the code reader everyone told me there wasn't any way to access codes except with john deere mechanic and laptop I really appreciate the info Al
  7. Replies
    2
    Views
    28,928

    check ford I/2 ton pickup I believe this pattern...

    check ford I/2 ton pickup I believe this pattern will fit the 14 inch Gator pattern
  8. Thread: Uphill slip?

    by campoman
    Replies
    1
    Views
    34,337

    I had a similar problem with a friends Gator but...

    I had a similar problem with a friends Gator but not a diesel, he had a aftermarket belt on it we put a factory belt from JD problem over,hope this helps
  9. Replies
    6
    Views
    43,175

    when ever you go to a bigger tire you are...

    when ever you go to a bigger tire you are changing the gear ratio I went from27 inch to 28 for a little more ground clearance it changed it a little but was acceptable , I don't know if john deere...
  10. unfortunately john deere wont allow us to use...

    unfortunately john deere wont allow us to use code readers or scanners on there equip, this needs to be changed not all of us can afford to take it tobjohn deere for diagnosis and repair,in the mean...
  11. Replies
    2
    Views
    6,201

    check all your grounds

    check all your grounds
  12. Replies
    5
    Views
    49,763

    battery voltage

    getting back to this your battery could be shorted or sulfated, locate a load tester and check voltage under a load , should hold at least 10 volts for 15 seconds if it drops down below 10 volts you...
  13. Replies
    0
    Views
    40,112

    floor mats for 825i

    I have templates for floor mats on the 825i if any one is in need 5.00 plus shipping
  14. Replies
    2
    Views
    35,904

    don't know what they are using but the silent...

    don't know what they are using but the silent rider muffler does quiet them down quite a bit I have one that I installed on my 825i but ended up not using it because it interfeared with a hitch that...
  15. Replies
    0
    Views
    1,985

    winch purchase

    any one thinking about buying a 3500 or 4500# winch , you might want to consider this and save yourself a lot of money I bought a 2500# super winch and a snatch block which doubles the pulling...
  16. clutch lube

    thanks for that Brad , have seen so many videos and info on that issue but makes sense I agree seems that lube on the clutch would just collect dirt , and there is never any thing said in the...
  17. Replies
    3
    Views
    6,492

    Sorry didnt mention about application , i have an...

    Sorry didnt mention about application , i have an 825i gator , this silent rider is new ran it for a day worked and knocked down the sound quite a bit but interfeared with a rear hitch application i...
  18. Thread: snorkle kit

    by campoman
    Replies
    3
    Views
    8,956

    snorkle kit

    I have fabricated a snorkel kit for the 825i I'm asking 125.00 plus shipping if interested contact me on this site or text me @6194051635 photos are on this site comes with mounting bracket hose...
  19. Replies
    5
    Views
    10,333

    you can buy diamond pattern black mat on line or...

    you can buy diamond pattern black mat on line or a lot of the hardware store carry it ,make a pattern out of card board and cut to fit at half the price
Results 1 to 19 of 19