About to order the Boss V Plow and hopefully a Prosum cab

[hornadylnl]

I'm in the process of selling some stuff off and hope to have my order in for the Boss V plow by the end of the week. I've got one last thing to sell and hopefully will be ordering the full Prosum cab as well. I'll at least order the windshield and roof with the front lights and wiper. This will ensure that I don't get any snow this winter.

[DIXIEDOG]

This will ensure that I don't get any snow this winter.

Guess we'll all owe you one


Judging from your user name is it safe to say you're into reloading a bit? I like my Hornady LNL AP press pretty dang well....it's a great piece of equipment.

[hornadylnl]

I've got an lnl ap with case feeder. Got an 8 ball handle on it as well.

[DIXIEDOG]

I've got an lnl ap with case feeder. Got an 8 ball handle on it as well.

The ultimate bling

[hornadylnl]

I tried a dillon roller handle and hated it. The factory ball rubs your hand raw after awhile with the mold rib. The 8 ball is great.

[DIXIEDOG]

I've left the factory round grip on mine and never had an issue....must have been lucky or haven't used it enough yet. I think they changed the design on the later ones a bit...mine is fairly old. Pre EZ Eject series....I put the EZ Eject plate on and modified all my shell plates to be EZ Eject ones. That was a nice improvement over the original design.

[hornadylnl]

I got the new ez eject parts but I haven't gotten the shell plates yet.

[DIXIEDOG]

I got the new ez eject parts but I haven't gotten the shell plates yet.

Do you have a mill? Or know somebody who works in a machine shop?



It took about 5 minutes per plate to fix them.....I tossed a 1/4" emill in and put the plates on a rotary table....bolt through the center so you can just loosen a nut slide that plate off....slip your next plate on and repeat. Hornady snags $10 a plate which isn't terrible but a buddy or you could do it for much cheaper....I expected the plates were going to be hardened but they cut like butter.

If you have a rotary table it could even be done on a small drill press.

[hornadylnl]

I haven't used the press for awhile so I haven't done anything with it. I don't really have access to a mill.

[hornadylnl]

I just sent out the check for the Boss V plow, smart hitch, shoes, and leg strap today. I'll get it some time after Labor Day (at my request. Not sure how soon I could get it otherwise). $3250 delivered is the best price I found. If anyone is interested, I got it through Red's Garage out of New York.