|
-
Senior Member
Update on RSX
Well, I have a 150 miles on her now and still running like a bear. I recieved the letter from JD saying the factory installed oil filter can leak but had already replaced it so didn't have to worry. I have tested the 4wd and diff lock in different trail situations and can honestly say this is my favorite utv. The skid plate has held up quite well and have had to slide over some fallen trees covered in snow which was fun. The only thing I would change is the bed pins are a bit noisy without a load. If they had some rubber isolators on them I think that would take care of it. I think I am going to try and put some rubber tubing over them so the don't rattle.
Last edited by 825joe; 08-15-2013 at 06:21 AM.
Moscow Lodge PA #504
2018 825e--- Warn 4500 ProVantage s winch, LED pod lamps, K&N Dry flow air filter, Super ATV half windshield, KFI 66" plow.
RSX 850i- Camo Trail model.--JD Half Windshield, Sport Roof. (sold)
2011 Camo 825i--- 4500lb Superwinch Terra series, K&N Hybrid dry flow filter, Warn 350F wireless fog lights, Kolpin half windshield. (Traded in.)
-
-
-
-
Senior Member
My half windshied directs the air over my head pretty good suprisingly.
Moscow Lodge PA #504
2018 825e--- Warn 4500 ProVantage s winch, LED pod lamps, K&N Dry flow air filter, Super ATV half windshield, KFI 66" plow.
RSX 850i- Camo Trail model.--JD Half Windshield, Sport Roof. (sold)
2011 Camo 825i--- 4500lb Superwinch Terra series, K&N Hybrid dry flow filter, Warn 350F wireless fog lights, Kolpin half windshield. (Traded in.)
-
-
Member
I been trying to fix the noisy bed, Haven't had any luck yet.
-
-
Junior Member
Originally Posted by 825joe
Well, I have a 300 miles on her now and still running like a bear. I recieved the letter from JD saying the factory installed oil filter can leak but had already replaced it so didn't have to worry. I have tested the 4wd and diff lock in different trail situations and can honestly say this is my favorite utv. The skid plate has held up quite well and have had to slide over some fallen trees covered in snow which was fun. The only thing I would change is the bed pins are a bit noisy without a load. If they had some rubber isolators on them I think that would take care of it. I think I am going to try and put some rubber tubing over them so the don't rattle.
Don't know if you saw it or not, but the bed latch pin brackets are adjustable. Look at the bracket that the pins are attached to, there is M8 fastener that can be loosened, and then the bracket will move up or down to adjust the pins. So If the bed is rattling, just adjust the pin bracket down a little, tighten the fastener, and latch the bed. Do each side equal, and go just a little at a time till you get it snug!
Hope this helps!
-
-
Senior Member
Thanks bud. Good info.
Moscow Lodge PA #504
2018 825e--- Warn 4500 ProVantage s winch, LED pod lamps, K&N Dry flow air filter, Super ATV half windshield, KFI 66" plow.
RSX 850i- Camo Trail model.--JD Half Windshield, Sport Roof. (sold)
2011 Camo 825i--- 4500lb Superwinch Terra series, K&N Hybrid dry flow filter, Warn 350F wireless fog lights, Kolpin half windshield. (Traded in.)
-
|