airbournein2001
09-16-2011, 10:52 PM
To all those that have seen the engine temp go into the black and have the cooling fan come on, the answer is "grounding". I know this has been discussed, but for those attempting to DIY, I had my dealer print off the service manual instructions for me. They were too busy to get to it before I needed it. Harvest time here in central MS and a lot of farmers are hurting with equipment.
Anyway, the instructions from Deere want the "102E" labeled ground wire cut close to the connector and grounded to the radiator bracket. However this wire is supposed to be in a connector with three wires, one yellow and two black. I never found a connector set up like this. I did find the "102E" labeled wire in the LCD connector. I cut it, spliced on, and grounded it as identified. This led to me not having anything displayed on the screed after start up.
I did find a connector under the removable tray that I think was the "102E" ground and moved it to the radiator bracket. It was on a spare connector with only two wires. Hopefully this will correct the problem!
anyway, hope this may help someone in the future. I have the complete instructions on hand if anyone needs a look.
Anyway, the instructions from Deere want the "102E" labeled ground wire cut close to the connector and grounded to the radiator bracket. However this wire is supposed to be in a connector with three wires, one yellow and two black. I never found a connector set up like this. I did find the "102E" labeled wire in the LCD connector. I cut it, spliced on, and grounded it as identified. This led to me not having anything displayed on the screed after start up.
I did find a connector under the removable tray that I think was the "102E" ground and moved it to the radiator bracket. It was on a spare connector with only two wires. Hopefully this will correct the problem!
anyway, hope this may help someone in the future. I have the complete instructions on hand if anyone needs a look.