View Full Version : OPS Cab door problem??
duling
10-04-2011, 08:03 AM
Anyone had any issues with their OPS cab doors popping open? I was riding with my son this weekend and my driverside door just popped open when I hit a bump. My son is only 2 so I wasn't flying, maybe 20mph, and I was on a gravel road so it wasn't a hard hit. As luck would have it when the wind caught it the cable came off and the door blew all the way back bending the frame, hinges, and supports. I am thinking this was an adjustment issue from the dealership, (not latching well and this was my first ride with the doors on), but I don't know if they are going to buy that. I am taking it in next week to get the front driveshaft taken care of so I'll see if I can get them to fix this as well.
Has anyone had any similar issues?
Thank you!
lcarr
10-06-2011, 05:06 PM
I sold a new 825i with the Poly cab and my customer had the same issues, except his didn't bend or break anything. I/ We have decided that for the small difference in price, we would just sell the Glass cab only from now on. I think the price difference was less than $1,000 and the Glass cab fits much better!
duling
10-07-2011, 07:54 AM
Unfortunately, my dealer didn't mention that to me beforehand and now they won't adress the issue without charging me labor. I actually think I may have fixed it; the upper hinge seemed to be placed further toward the rear of the vehicle than the lower one so I adjusted that and the door fits perfectly. Hopefully it stays that way. Thanks for the info.
jd35154
10-17-2011, 01:27 PM
Had the same problem with one of our 825i cabs. It is hard to tell but the little door latches themselves are adjustable. Just loosen up the small bolts and they will slide back and forth.
Hope this helps
duling
10-18-2011, 07:48 AM
Awesome, thank you. I thought they might adjust but I wasn't sure enough to go messing with it.
While toying with my door fiasco I found that two of the bolts that go through the metal plate above the gas tank and into the back plate of the cab seem to be too long and are pushing the plastic backing of the cab out against the bed. Anyone else have this issue? It is causing the bed to rub a hole in the back of my poly cab. I can't tell if the bolt is in backwards or if its simply the wrong bolt. Hopefully the dealer will fix this for me... stay tuned.
Powered by vBulletin® Version 4.2.2 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.