PDA

View Full Version : Full Cab System by Prosum Equipment



ncbowhnter
01-19-2012, 12:26 PM
Does anybody have any experience with this system? Looking for pros and cons....
http://www.prosumequipment.com/Contact.html

plateauman57
01-19-2012, 07:35 PM
first ive seen of them not bad looking what do they run?

ncbowhnter
01-19-2012, 08:12 PM
A little cheaper than JD poly cab....roughly 2600
but with a glass windshield

2255puller
01-19-2012, 11:02 PM
Does that include the roof? Does the glass windsheild have a wiper?

ncbowhnter
01-19-2012, 11:15 PM
here is what I've got so far from this company. I am really researching hard and this seems to be one of the best set ups out there.
glass windshield-420
rear sliding window-295
roof-295
light kit-230
doors with glass-1400
roughly 200 shipping
did not price the wiper kit but they do have one

the only negative thing that I have seen so far is the it would take a little longer to take off the windshield for the warmer months/trailering. it requires removing 4 screws which I would imagine would wear out over time if you took it off a bunch.
I have also looked at FTD's stuff which also looks really nice. I have thought about the windshield, roof and back window from them, but it would be nice to have the option of doors later on down the road if I felt that I needed them. The FTD system does not have a door option.......
decisions, decisions.

Gator Hunter
01-19-2012, 11:16 PM
I like the way the doors hinch on the front vs the back. I wish the JD doors did that! Looks like the back window has a "rubber like" membrane vs solid poly like Deere.

Deputy347k9
01-20-2012, 06:28 AM
NCbowhunter, I also have checked into this cab several times, from the company Scott has sent me all the information regarding the setup. One of your concerns is removing the front glass during warmer weather. I really don't see many people removing the windshield once installed. With the door off I think you will have ample air flow. I drove my machine in early summer with no windshield, trying to drink a cup of coffess was difficult.

One other thing I really liked about this setup was you can build it as you go. There is no real price difference when you purchase the setup one piece at a time, only extra shipping cost. Before I notice this setup I had purchased from John Deere my poly top, rear screen and front windshield. Quite a handful of money spent. Without quesiton, if I had to do it again it would be this setup and nothing else. Just my 2 cents!

vicmic83
02-03-2012, 07:57 PM
I bought the complete PROSUM cab 3 weeks ago (1st week on January). Looks sharp, sturdy. Took a couple of days to install. The real trick is aligning the doors to fit flush. Finally figured it out. Glass windshield, glass in the doors, glass rear slider. (Tempered). I purchased the interior light and rear lights with the package. While plowing in 28 degree weather with some wind it was perfect on the inside. I think the engine heat is captured in the cab. Installed a Radio... (weatherproof boat type). Bought a Lift Kit off ebay for $425. Slightly used contains everything. No complaints about the Cab, however minimual snow fall in lower Michigan. If your looking for a lift kit... the Seller has sold about 20 at that price.

skimiljes
03-12-2012, 02:34 PM
I have looked long and hard at all the cabs. I think I have decided to go with PROSUM cab, I think:)... I dont have a need for doors at this time, but if I did it is nice to know I can add them. I like the ruggedness of the FTD cabs but the glass windshield made my decision for me. I am going to continue to look but other than the deluxe cab does any other manufacture make a glass windshield?

Regulator
03-12-2012, 03:56 PM
Vicmic83....what lift kit are you talking about???....is it for an 825i???...I have been looking for a lift kit for my Gator for awhile now and haven't found a thing....if it is, could you please give me the link to the seller on ebay???...I would be extremely grateful!!!

Thanx man...

Larry in MD :Jestr:

tonywesglen
10-16-2012, 07:54 PM
just ordered Prosum cab so whats the answer to your statement The real trick is aligning the doors to fit flush. Finally figured it out.

vicmic83
11-10-2012, 12:20 PM
Vicmic83....what lift kit are you talking about???....is it for an 825i???...I have been looking for a lift kit for my Gator for awhile now and haven't found a thing....if it is, could you please give me the link to the seller on ebay???...I would be extremely grateful!!!

Thanx man...

Larry in MD :Jestr:

Late getting back to you. I purchased the Lift Cylinder for the box. Works great used it alot this last summer. 625i. Gator is all waxed and armouraled for winter.