PDA

View Full Version : Relocating Gas Tank Vent (video)



GatorOffroad.com
03-22-2012, 05:39 PM
http://www.youtube.com/watch?v=Dujcy-i7lZo&feature=g-u-u&context=G27d4f4aFUAAAAAAAEAA

Deputy347k9
03-22-2012, 08:25 PM
Thank you very much for the video, very helpful information. So much easier when you see it done!

Larry in ME

CaptDan
03-23-2012, 03:52 AM
Thank you very much for the video, very helpful information. So much easier when you see it done!

Larry in ME

:IAgre::IAgre:

Thank you !

Dan

Regulator
03-23-2012, 10:31 AM
Very cool!!!!...thanx a bunch for posting the video...

Larry in MD :Jestr:

GatorOffroad.com
03-23-2012, 02:05 PM
No problem guys. Let me know if there are any other videos you'd like to see and we'll try to make them happen.

jdman
03-24-2012, 12:23 AM
Very helpful I am goin to check mine tomorrow!!!!

pcbunn
03-24-2012, 01:26 PM
Would it be just as effective to install the filter on the end of the vent tubing where it terminates at the battery box? And what kind of filter is it, motorcycle or what and where did you get it, Napa? Thanks

GATORDONE
03-24-2012, 01:37 PM
I would not vent it into the battery box unless you want a passenger side ejection seat!:Nnd:

CaptDan
03-24-2012, 06:29 PM
I would not vent it into the battery box unless you want a passenger side ejection seat!:Nnd:

:IAgre::IAgre: :lol: :hehe: :lol: :hehe:

Dan

pcbunn
03-24-2012, 07:35 PM
But why? The vent sucks air in mostly and the battery is completely sealed! I quess I just don't see any reason to extend the vent up to the front storage area if you don't need to?

Kiwi06
03-25-2012, 02:33 AM
Personally, I think likelihood of explosion is very small. I agree that the vent will mostly be an intake, and when it's not, there will still be very little fuel vapor in the battery area. In addition, I don't believe the battery is fully sealed (mine isn't), but that doesn't increase concern about fuel vapor explosion. I understand concern about sparks and the fuel vapor, but the hydrogen gas that the battery out gasses is far more explosive. Still, risk is minimal. I will, however, probably run my vent up higher to minimize fuel spills from overfilling the tank.

- Steve

osiris
03-25-2012, 10:06 AM
possibly i missed something here and the internet is so slow here at work i cannt view the movie.. but what is there to gain my relocating your vent, chances are your going to suck water in your intake or get your drive belt wet before your gas tank is submerged :hdscrh:

jandrold
03-25-2012, 10:42 AM
Just about every morning when the air temperature goes up the fuel expands and the vapors are vented out this vent. Not much but it does. the line can be vented into the aircleaner housing and the fumes burned in the engine.
Jim O.
USMC Ret.

jandrold
03-25-2012, 11:58 AM
Just went out and pulled the airfilter and canister out, studing it noticed that it looks like at one time they were going to vent this tank vent into the breather and cast a place for a fitting into this canister, all engines today have some sort of vapor recovery system on them, a vapor return system that the fumes are vented back to the throttle body to be burned in the engine, Also, not related to the fuel vent, the air inlet that is cast into this canister is really did I say really reduced down and for some reason limites the amount of air that it can pull into the engine. Someone in another post talking about relocating the airfilter said that we need to watch the size of tubing used because it will limit performance. After seeing this air restriction that JD cast into the canister they have put a real limit on the output of this engine.

Jim O.
USMC Ret.

Kiwi06
03-26-2012, 01:57 AM
OK, I took a look and followed the vent hose (easy for me since I have the bench seat). Instead of heading to the battery box floor, it turns back to the engine compartment, through (I'm guessing) a check valve and probably then on to the throttle body. (No need for me to reroute! :BG:) For a point of reference, my mfg date is listed as end of Sept. '11.

- Steve in lovely CO

jandrold
03-26-2012, 09:28 AM
Now that you found what you think is the vent line see if you can find the fuel line which passes throught the battery box area and exits aft to the engine compartment and than to a fuel filter and on to the engine. I also found what I thought was this vent line and it was the fuel line, Look between the battery and passenger side of the battery box area down at the bottom, there is only a inch or so its hard to see. Mine also was Mfg in sept of 2011. :hdscrh:

Jim O.
USMC Ret.

apple
03-26-2012, 09:44 PM
Relocated mine today; no problem. I got 7 feet of hose and used it all. Easy retro to maybe prevent a problem down the road.

allenflucas
03-26-2012, 10:01 PM
Do you know why the drivers side get so hot on the feet? Is something missing? Also, some people on here have been talking about changing the springs in the clutch so it takes off faster, mine seems so low speeded at start.. thanks for any help..

Kiwi06
03-28-2012, 02:42 AM
Now that you found what you think is the vent line see if you can find the fuel line which passes throught the battery box area and exits aft to the engine compartment and than to a fuel filter and on to the engine. I also found what I thought was this vent line and it was the fuel line, Look between the battery and passenger side of the battery box area down at the bottom, there is only a inch or so its hard to see. Mine also was Mfg in sept of 2011.

Thanks! I'll take another look tomorrow (maybe where there is enough light actually see rather than just feel :hehe:).

- Steve

GatorOffroad.com
03-28-2012, 03:29 PM
possibly i missed something here and the internet is so slow here at work i cannt view the movie.. but what is there to gain my relocating your vent, chances are your going to suck water in your intake or get your drive belt wet before your gas tank is submerged :hdscrh:

If you watch the video, you'll see that we relocated it because of dust entering the fuel tank through this line. Relocating the line and installing a small filter should help
keep dust out.

Regulator
03-28-2012, 03:56 PM
GatorOffRoad....hey bud...how are you all doing???....thanx again for the time you took to make those video's for all of us...I certainly appreciate it a bunch, as I am sure others here do too...I week or so ago, I posted up some pics of where I installed a bunch of the Eastwood brand "DynaMat" sound deadening/heat blocking material on my Gator to help with the excessive noise in the Cab and the heat coming up through to the inside...it worked really well for the sound deadening, as the engine now doesn't sound nearly as loud as it did, and also giving it a deeper tone...I am just mentioning this because I didn't know if you caught that, or if you had the same noise and heat problems like a bunch of others on here who have complained about both...it's in the "XUV Tech John Deere Gator XUV 2011 - ???" section under "Muffler Silencer", down the page a bit or so...it also helped the "wind flapping" noise that the Poly Cab rear section and roof used to do when going fast...the DynaMat stuff is heavy so it really made a difference in suring up the thin Poly Cab a bunch.......

Also...I want to do some clutch mods to mine one of these days...Team Industries is supposed to be putting out a clutch kit for these 825's here sometime soon...if you all want to do another informative video, you could do one on how to get into the clutch basket and show all the parts involved, like the two primary and secondary springs, and whatever else is in there that will need to be taken apart to work on the clutch....that's just an idea as you said that you would consider doing a video from suggestions that we might like to see...

Again, I appreciate you all doing these video's and sharing them with us...I totally enjoy the hell out of them!!!

Larry in MD :Jestr:

SEC605
10-26-2013, 02:48 PM
I don't see the video. Perhaps it was taken down since you originally posted. Can you repost?

SEC605
10-27-2013, 12:54 PM
It's there now. Thanks. Very helpful.