View Full Version : cluch filter
Gator Joe
07-12-2012, 11:44 AM
I have a 2012 825i gator and it keeps sucking the cluch filter down the tube to about hafe way down. It is doing this more and more to the point where every time I ride it I have to keep pulling the tube off and dig out the form filter. Does eany one else having this problem? Thank You. Gator Joe
plateauman57
07-12-2012, 12:30 PM
I havent had this problem myself but i think i read a previous thread where some were and someone mentioned running a wire tie through it to keep it in place. you should be able to search the threads and find that.
Gator Joe
07-12-2012, 12:38 PM
Thanks a lot for the info I'll try that and see if that works.
JPalmer
07-12-2012, 03:36 PM
i had that problem but i fixed by taking one of those clamps that has a screw on and you turn it to tighten it (the clamp you use to secure you dryer exhaust hose to the dryer) i put on the outside of the black intake hose just about where the middle of the filter sits on the inside and thightened just a little bit and solved my problem.
Skillet23
07-12-2012, 03:53 PM
Yeah I had this problem also. I took some stainless steel wire and went through the hose, through the filter and back through the hose and tied it off. Did this in an X pattern. No problems since.
David in TX
Gator Joe
07-12-2012, 05:42 PM
Thanks for the help I am getting tired of taking off that hose every time I ride it to get the filter out of the hose. Gator Joe
Txcoastjason
07-12-2012, 11:10 PM
Good pointer! So easy. Didn't even think about that.
GATORDONE
07-13-2012, 09:33 AM
Here is a simple filter holder i made from #9 wire that works great.
ATTACH=CONFIG]1230[/ATTACH]1231
Gator Joe
10-01-2012, 06:22 PM
I want to Thank You GATORDONE I made a filter holders and it worked just fine Thanks for the help.
Gator Joe
10-01-2012, 06:26 PM
I am looking for a good winch for my 2012 825i is there one that is better than another?
Thanks Gatoe Joe
PeteWI
10-01-2012, 06:32 PM
This is why I subscribe to the forum. Thanks for the help in the filter holder.
pcbunn
10-01-2012, 09:14 PM
I just ran a couple of long screws into the filter from each side of the tube. I used screws that have an integral washer. Works fine and almost invisible until you want to remove the filter, plus you don't have to worry about anything falling into the tube.
IdleUp
10-06-2012, 10:55 AM
Do a search on Ebay - there is one for the Gator complete with bracket and a good price.
Mike
Powered by vBulletin® Version 4.2.2 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.