PDA

View Full Version : Couple questions from a new 825i owner



DIXIEDOG
08-05-2012, 10:09 AM
I just traded my RTV 500 in for a Gator 825i and had a few questions about it.....being used to the Kubota and it's hydro tranny and overall smoothness I wasn't sure about some things


1) Should the machine take a lot of rpms to move? Seems like the clutch doesn't even engage until 2k+...it's not bad when riding but it kinda sucks when I'm driving it on the trailer and need to go another 4" or so....every time I left off the brake it rolls back and I end up driving it forward again but it won't just ease into place. Is this an adjustment or do I just need to get used to it?

2) Hot smell...I took it for a ride through a few rough trails yesterday for a good try out and it has a hot smell....can't really describe it except it's like paint or plastic burning...I looked under the buggy and there isn't any smoke so I'm guess it's just the exhaust burning in or something minor. Is it normal?

3) Besides steel stick stoppers for the CV's are there any other must have add ons that will keep me from breaking this thing in the woods?

4) Do the brakes improve over time? The brakes seem weak and the E-brake does also..it needs to be fully engaged just to stop the buggy from rolling. Is that normal?

So far the machine is pretty impressive....it went through areas I never would have considered taking my RTV and did them with ease...the added ground clearance really makes a difference.

chzbrgr
08-05-2012, 01:38 PM
I just traded my RTV 500 in for a Gator 825i and had a few questions about it.....being used to the Kubota and it's hydro tranny and overall smoothness I wasn't sure about some things


1) Should the machine take a lot of rpms to move? Seems like the clutch doesn't even engage until 2k+...it's not bad when riding but it kinda sucks when I'm driving it on the trailer and need to go another 4" or so....every time I left off the brake it rolls back and I end up driving it forward again but it won't just ease into place. Is this an adjustment or do I just need to get used to it?
The clutch springs and weighted seem to be set to keep the engine in its peak range. It will get a little better as it breaks in.
2) Hot smell...I took it for a ride through a few rough trails yesterday for a good try out and it has a hot smell....can't really describe it except it's like paint or plastic burning...I looked under the buggy and there isn't any smoke so I'm guess it's just the exhaust burning in or something minor. Is it normal?
Mine had the the stink for a little while also. The more you run it, the faster that will disappear. :BG:
3) Besides steel stick stoppers for the CV's are there any other must have add ons that will keep me from breaking this thing in the woods?
I broke a front fender in the woods pretty quick. Still havn't done anything about that.
4) Do the brakes improve over time? The brakes seem weak and the E-brake does also..it needs to be fully engaged just to stop the buggy from rolling. Is that normal?
Brakes need to be burnished. Basicallly riding the brakes to get material embedded in the rotor. Your dealer will take care of that for you. It can be a little tricky because you don't want to overheat the rotors.So far the machine is pretty impressive....it went through areas I never would have considered taking my RTV and did them with ease...the added ground clearance really makes a difference.

Definate differences to the Kubota. You'll figure out when to use low gear and occasional two feet operation. Enjoy

srb08
08-05-2012, 06:26 PM
I added front fender guards as well as front brush guard and rear bumper. The front rack is handy as well.
Best,
Steve

DIXIEDOG
08-05-2012, 08:24 PM
I was thinking about the rear bumper....it already has the front brush guard and fender guards on it. I was backing right up against trees yesterday to maneuver it around a pretty rough "trail" and a rear bumper would likely be a good investment.:Ysnd:

DIXIEDOG
08-20-2012, 04:46 PM
Well I think I managed to wear the brakes in a bit....I've been using them hard enough that I'll likely have to replace them in another month o rtwo but at least they work pretty well now.:Thmup:


I already picked up and installed a rear bumper and cargo box protectors so the rear body should be pretty safe for awhile.....I've got the CV Guards all on order and this little buggy is about ready for some heavy use.

I ordered a factory winch plate kit off Ebay a couple weeks back so once that arrives I'll be more comfortable testing my limits a bit more knowing if I get stuck it won't be quite so difficult to get back out.:lol:




Do you guys carry any extra parts with you on days out in the woods or are these 825's dependable enough you don't need spare parts and a tool kit?

GATORDONE
08-20-2012, 05:06 PM
The most important part to carry is your cell phone! :Ysnd: gotten me out of a few jams.

puggsleys gator
09-08-2012, 11:55 PM
The phone idea is a good one! Sooner or later you may experience what I and many others on and off this forum have experienced. Drive train problems. Sounds which remind one of gear clash, and the jerking as one gear misses a tooth on the other one. Dealer has had mine 3 times! He's an hour away! I pretty much give up! I feel for those who need to use the 825 daily.

DominiEarl
09-11-2012, 09:54 PM
I added front fender guards as well as front brush guard and rear bumper. The front rack is handy as well.