PDA

View Full Version : 825i CVT?



DIXIEDOG
09-01-2012, 04:09 PM
Is it normal to have the approx 4" square opening that allows you to see your CVT belt and pulley wide open above the muffler on the rear of a 825i?

Jaykrebs
09-01-2012, 05:43 PM
isn't that where the warm air blows out of the cvt/belt housing?

K-DOG
09-05-2012, 01:18 PM
1412

Yes this is normal. The air is pulled in from the tube near the gas tank and exits the square opening you mention. There is a fan attached to the primary clutch (item C in the pic) that pulls the air.

DIXIEDOG
09-05-2012, 07:32 PM
It would have been nice to put a screen or something over it....seems like a heck of a place for critters to get in when it's parked. I guess time will tell.

Dane
09-05-2012, 08:35 PM
I've just moved up from a golf cart where the clutches and belt are totally exposed. I never had issue with the open arrangement on the golf cart except when I got crazy in the snow or drove through water too deep and the belt started to slip. Basically I'd have to say the CVT belt transmission stuff works pretty well and does not need to be sealed away. It may slip when wet but if not submerged the slipping quickly drys things off and you get your drive back.

Jaykrebs
09-06-2012, 09:52 PM
There should be a foam insert on the CVT intake, from the factory. Its a good idea to use some long screws or something to secure it in place, otherwise it tends to work its way down the CVT intake tube or fall out completely. Mine worked it's way nearly into the fan. I've also used 1/4" screen mesh to cover exhaust port on the CVT cooling housing/assembly. Think I might add some to the intake side in addition to the factory foam. CVT can make a nice warm place to hide, I really don't want to scrape chippy guts out of my CVT;)