MBDiagMan
07-30-2014, 09:15 PM
I have an 825i with serial number below 060000. A 2013 model as I remember. I bought it in September 2012.
Almost from the start it was hard to shift and they replaced the clutch under warranty. It is now again difficult to get in and out of gear.
I removed the clutch shrouding and was able to observe while running the engine. The belt was tight, that is, not slipping in the primary clutch. I stopped the engine and pulled on the outer primary clutch sheave to open the clutch, and it felt like I moved it, but not more than a 1/16". I started it back up and was able to change gears and the belt did not move while in gear.
I then revved it up and it then got hard to shift. I killed it again and could not move the belt. I pulled again on the outer clutch sheave until it moved and then was able to move the belt again.
Do I need to replace the clutch? That seems like overkill. Could I shim the spring to make it stay open? Is there a known problem with this clutch that I need to know about?
I did a search on clutch which led me to TEAM Clutches. They have a replacement clutch for $299 but it is sold to increase performance which I don't need, but if they have a high quality clutch that will be reliable, I will pay the money for their clutch.
Thanks in advance for sharing any experience that you might have.
Almost from the start it was hard to shift and they replaced the clutch under warranty. It is now again difficult to get in and out of gear.
I removed the clutch shrouding and was able to observe while running the engine. The belt was tight, that is, not slipping in the primary clutch. I stopped the engine and pulled on the outer primary clutch sheave to open the clutch, and it felt like I moved it, but not more than a 1/16". I started it back up and was able to change gears and the belt did not move while in gear.
I then revved it up and it then got hard to shift. I killed it again and could not move the belt. I pulled again on the outer clutch sheave until it moved and then was able to move the belt again.
Do I need to replace the clutch? That seems like overkill. Could I shim the spring to make it stay open? Is there a known problem with this clutch that I need to know about?
I did a search on clutch which led me to TEAM Clutches. They have a replacement clutch for $299 but it is sold to increase performance which I don't need, but if they have a high quality clutch that will be reliable, I will pay the money for their clutch.
Thanks in advance for sharing any experience that you might have.