View Full Version : wires to the roof
Harry Ferguson
12-08-2014, 11:15 AM
How does one customarily run electric wires from the dash up to the top of the roll cage? I'm preparing to add a dome light and some rear work lights on top and don't want a bunch of exposed wires strapped to the roll bar. I found a drain hole in the bottom of each front leg of the cage. Am contemplating drilling a small hole in the tube inside one of the upper welded gussets, and snaking the wires through the roll bar front tube. Anybody have a better idea?
scoobieguy
12-08-2014, 10:22 PM
http://www.johndeeregatorforum.com/forum/showthread.php?12377-550-Roof-Lights-Installation
(http://www.johndeeregatorforum.com/forum/showthread.php?12377-550-Roof-Lights-Installation)These 2 posts show ho you can fish wires from the bottom of roll cage to the top using factory holes
http://www.johndeeregatorforum.com/forum/showthread.php?12736-825i-overhead-light-wiring-and-switch
Harry Ferguson
12-09-2014, 10:13 AM
thanks, scoobieguy,
I didn't see the factory hole but that beats drilling through the powdercoat. Looks like the standard route is through the open end of the rear rollbar tube.
Bunky
12-09-2014, 07:33 PM
My dealer was too lazy to separate the OPS to run the wiring through the OPS. It does not bother me.
Powered by vBulletin® Version 4.2.2 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.